Advantech MIC-3392 User Manual

User ManualMIC-3392 Rev.26U CompactPCI Intel Core 2 Duo Processor Based Board with Dual PCIe GbE/DDR2/SATA/PMC

MIC-3392 Rev.2 User Manual xTable A.11:RJ1 LAN1 Indicator ... 57Table A.12:RJ2 LAN2 Indicator ...

Chapter 11 Hardware ConfigurationThis chapter describes how to configure MIC-3392 hardware.

MIC-3392 Rev.2 User Manual 21.1 Introduction The MIC-3392 is a high performance, power efficient CompactPCI single-board com-puter based on the Intel

3 MIC-3392 Rev.2 User ManualChapter 1 Hardware Configuration1.2 Specifications1.2.1 CompactPCI Bus InterfaceThe MIC-3392 is compliant with PICMG 2.0 R

MIC-3392 Rev.2 User Manual 4improved storage speed and reliability. Features include an integrated 32-bit 3Dgraphics engine based on Intel Graphics Me

5 MIC-3392 Rev.2 User ManualChapter 1 Hardware Configuration1.2.6 MemoryThe MIC-3392 has up to 2 GB of onboard non-ECC DDR2 memory. In addition, anSOD

MIC-3392 Rev.2 User Manual 61.2.7 EthernetThe MIC-3392 uses two Intel 82573E LAN chips to provide 10/100/1000Base-TEthernet connectivity (LAN1 & L

7 MIC-3392 Rev.2 User ManualChapter 1 Hardware Configuration1.2.14 Mechanical and Environmental Specifications! Operating temperature: 0 ~ 55° C (32 ~

MIC-3392 Rev.2 User Manual 81.2.17 I/O ConnectivityFront panel I/O is provided by two RJ-45 Gigabit Ethernet ports, one RJ-45 COMport, two USB 2.0 por

9 MIC-3392 Rev.2 User ManualChapter 1 Hardware Configuration1.2.23 HPET and IO/APICThe MIC-3392's built-in south bridge, the ICH7, provides featu

MIC-3392 Rev.2 User Manual iiCopyrightThe documentation and the software included with this product are copyright 2008 byAdvantech Co., Ltd. All right

MIC-3392 Rev.2 User Manual 101.4 Jumpers and SwitchesTable 1.4 and table 1.5 list the jumper and switch functions. Figure 1.2 illustrates thejumper an

11 MIC-3392 Rev.2 User ManualChapter 1 Hardware Configuration1.4.3 Switch SettingsSW5-1 selects the LAN port that is used for Serial Over LAN (SoL) fu

MIC-3392 Rev.2 User Manual 12When COM2 is not used as a console interface, it is used to communicate BMC infor-mation via the onboard SIO COM2 or RTM

13 MIC-3392 Rev.2 User ManualChapter 1 Hardware ConfigurationFigure 1.2 MIC-3392 Rev.2 jumper, switch and connector locations

MIC-3392 Rev.2 User Manual 141.5 Connector DefinitionsOnboard connectors link to external devices such as hard disk drives, keyboards orfloppy drives.

15 MIC-3392 Rev.2 User ManualChapter 1 Hardware Configuration1.5.1 VGA Display Connector (VCN1 or rear I/O)The MIC-3392 incorporates the Intel 945GME

MIC-3392 Rev.2 User Manual 161.5.6 Ethernet Configuration (RJ1/RJ2 or Rear I/O RJ1)The MIC-3392 is equipped with two high performance, PCI-Express bas

17 MIC-3392 Rev.2 User ManualChapter 1 Hardware Configuration1.7 Installing the CPU and HeatsinkThe MIC-3392 supports Intel Core Duo/Solo and Core 2 D

MIC-3392 Rev.2 User Manual 181.7.1 CPU & Heatsink Installation StepsThe MIC-3392 contains electrostatically sensitive devices. Please discharge yo

19 MIC-3392 Rev.2 User ManualChapter 1 Hardware Configuration7. Fasten the heatsink to the base plate.1.8 Battery ReplacementThe battery model number

iii MIC-3392 Rev.2 User Manual Declaration of ConformityCEThis product has passed the CE test for environmental specifications when shieldedcables are

MIC-3392 Rev.2 User Manual 20

Chapter 22 AMI BIOS SetupThis chapter describes how to configure the AMI BIOS.

MIC-3392 Rev.2 User Manual 222.1 Introduction The AMI BIOS has been customized and integrated into many industrial and embed-ded motherboards for over

23 MIC-3392 Rev.2 User ManualChapter 2 AMI BIOS Setup2.2 Entering SetupTurn on the computer and check for the “patch” code. If there is a number assig

MIC-3392 Rev.2 User Manual 242.3 Main SetupWhen you first enter the BIOS Setup Utility, you will enter the Main setup screen. Youcan always return to

25 MIC-3392 Rev.2 User ManualChapter 2 AMI BIOS Setup2.4 Advanced BIOS Features SetupSelect the Advanced tab from the MIC-3392 setup screen to enter t

MIC-3392 Rev.2 User Manual 262.4.1 CPU ConfigurationFigure 2.5 CPU Configuration2.4.1.1 Max CPUID Value LimitIt is recommended that you leave this val

27 MIC-3392 Rev.2 User ManualChapter 2 AMI BIOS Setup2.4.2 LAN & SMbus ConfigurationFigure 2.6 LAN & SMBus Configuration2.4.2.1 Select LAN1/LA

MIC-3392 Rev.2 User Manual 282.4.3 IDE ConfigurationFigure 2.7 IDE Configuration2.4.3.1 ATA/IDE ConfigurationThree options are available: Disabled, Co

29 MIC-3392 Rev.2 User ManualChapter 2 AMI BIOS Setup2.4.4 Floppy ConfigurationFigure 2.8 Floppy Configuration! Floppy A: Select the type of floppy dr

MIC-3392 Rev.2 User Manual ivWarnings, Cautions and NotesDocument FeedbackTo assist us in making improvements to this manual, we would welcome comment

MIC-3392 Rev.2 User Manual 302.4.5 Super I/O ConfigurationFigure 2.9 Super I/O Configuration! Onboard Floppy Controller: Used to enable or disable the

31 MIC-3392 Rev.2 User ManualChapter 2 AMI BIOS Setup2.4.6 ACPI SettingFigure 2.10 ACPI SettingThe options for “ACPI Aware O/S” are “Yes” or “No” in o

MIC-3392 Rev.2 User Manual 322.4.8 Console Redirection ConfigurationFigure 2.12 Configure Remote Access types and parameters2.4.8.1 Remote AccessYou c

33 MIC-3392 Rev.2 User ManualChapter 2 AMI BIOS Setup2.4.9 APM ConfigurationFigure 2.13 APM configurationAPM allows the BIOS to control the system’s p

MIC-3392 Rev.2 User Manual 342.5 PCI/PNP SetupSelect the PCI/PnP tab from the MIC-3392 setup screen to enter the Plug and PlayBIOS Setup screen. You c

35 MIC-3392 Rev.2 User ManualChapter 2 AMI BIOS Setup2.6 Boot SetupFigure 2.15 Boot Setup2.6.1 Boot Settings ConfigurationFigure 2.16 Boot Settings Co

MIC-3392 Rev.2 User Manual 36! Boot From LAN1/2/3 Support: Used to set the system bootable from LAN1/2/3. The default setting is on “Disabled“.! Wait

37 MIC-3392 Rev.2 User ManualChapter 2 AMI BIOS Setup2.8 Advanced Chipset SettingsFigure 2.18 Advanced Chipset Setting2.8.1 North Bridge Chipset Confi

MIC-3392 Rev.2 User Manual 38! DRAM Frequency: Available settings are “Auto” (default), “400MHz”, “533MHz”, and “667MHz”.! Configure DRAM timing by SP

39 MIC-3392 Rev.2 User ManualChapter 2 AMI BIOS Setup2.9 Exit OptionFigure 2.21 Exit Option2.9.1 Save Changes and ExitWhen you have completed the syst

v MIC-3392 Rev.2 User Manual Safety Instructions1. Read these safety instructions carefully.2. Keep this User Manual for later reference.3. Disconnect

MIC-3392 Rev.2 User Manual 40

Chapter 33 IPMIThis chapter describes IPMI con-figuration.

MIC-3392 Rev.2 User Manual 423.1 IntroductionThe MIC-3392 fully supports the IPMI 2.0 interface and the PICMG 2.9 R1.0 specifi-cation. The Renesas H8S

43 MIC-3392 Rev.2 User ManualChapter 3 IPMI3.3.1 IPMI Device Global Commands3.3.2 BMC Device and Messaging InterfacesThe BMC messaging interfaces comp

MIC-3392 Rev.2 User Manual 443.3.3 BMC Watchdog Timer CommandsTable 3.4: BMC Device and Messaging CommandsBMC Device and Messaging Commands NetFn Cmd

45 MIC-3392 Rev.2 User ManualChapter 3 IPMI3.3.4 Chassis Device Commands3.3.5 Event Commands3.3.6 PEF and Alerting CommandsTable 3.6: Chassis Device c

MIC-3392 Rev.2 User Manual 463.3.7 SEL Device Commands3.3.8 SDR Device Commands3.3.9 FRU data The MIC-3392 supports the IPMI FRU function to store acc

47 MIC-3392 Rev.2 User ManualChapter 3 IPMI3.3.10 Sensors and Threshold configurationSensor data record (SDR) repository will be stored in BMC's

MIC-3392 Rev.2 User Manual 483.3.11 Serial over LANThe MIC-3392 supports Serial over LAN (SOL). This can be used for implementing avirtual remote seri

49 MIC-3392 Rev.2 User ManualChapter 3 IPMI3.3.12 Serial/Modem Device Commands3.4 BMC Reset The BMC can initiate a graceful shutdown of the MIC-3392 b

MIC-3392 Rev.2 User Manual viSafety Precaution - Static ElectricityFollow these simple precautions to protect yourself from harm and the products from

MIC-3392 Rev.2 User Manual 50

Appendix AA Pin AssignmentsThis appendix describes pin assignments.

MIC-3392 Rev.2 User Manual 52A.1 J1 ConnectorTable A.1: J1 CompactPCI I/O Row A Row B Row C Row D Row E Row F1 +5 V -12 V TRST# (NC) +12 V +5 V GN

53 MIC-3392 Rev.2 User ManualAppendix A Pin AssignmentsA.2 J2 ConnectorTable A.2: J2 CompactPCI I/O Row A Row B Row C Row D Row E Row F1 CLK1 GND

MIC-3392 Rev.2 User Manual 54A.3 J3 ConnectorTable A.3: J3 CompactPCI I/O (LPT, FDD, Parallel IDE, 2.16) Row A Row B Row C Row D Row E Row F1 LPT_

55 MIC-3392 Rev.2 User ManualAppendix A Pin AssignmentsA.4 J5 ConnectorA.5 Other ConnectorsTable A.4: J5 CompactPCI I/O (VGA, LAN, COM, USB, PS/2)Row

MIC-3392 Rev.2 User Manual 56Table A.6: CN9 COM1 (RJ45) Connector1 DCD# 6 DSR#2SIN 7 RTS#3SOUT 8 CTS#4DTR#5GNDTable A.7: CN11 & CN12 USB port 1 &a

57 MIC-3392 Rev.2 User ManualAppendix A Pin Assignments7 GND 8 GND9 GND 10 SATA_RX0N11 GND 12 SATA_RX0P13 GND 14 GND15 RSV (+3.3 V/+12 V) 16 +5 V17 RS

MIC-3392 Rev.2 User Manual 58A.5.1 M/D, PWR & IDE/Hot-swap LEDsName Description1 M/D (Green) Indicates Master or Drone mode status 2 PWR (Green) I

Appendix BB Programming the Watchdog TimerThis appendix describes how to program the watchdog timer.

vii MIC-3392 Rev.2 User Manual ContentsChapter 1 Hardware Configuration...11.1 Introduction ...

MIC-3392 Rev.2 User Manual 60B.1 Watchdog Timer Programming ProcedureTo program the watchdog timer, you must execute a program that writes a value to

Appendix CC CPLDThis appendix describes CPLD configuration.

MIC-3392 Rev.2 User Manual 62C.1 Features! Drone Mode! Hot-Swap: Hot insertion and removal control! CompactPCI Backplane: CompactPCI slot Addressing !

63 MIC-3392 Rev.2 User ManualAppendix C CPLDC.2.3 Watchdog Disable RegisterC.2.4 Geography Address (GA)This read-only address shows the CPCI backplane

www.advantech.comPlease verify specifications before quoting. This guide is intended for referencepurposes only.All product specifications are subject

MIC-3392 Rev.2 User Manual viii1.5.3 USB Connector (CN11/12 and Rear I/O)... 151.5.4 CompactFlash Socket (CN10) ...

ix MIC-3392 Rev.2 User Manual Figure 2.20South Bridge Configuration .......... 382.9 Exit Option.......