Advantech PCA-6188 User Manual Page 32
- Page / 124
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
PCA-6188 User’s Manual 16
Chapter 2 Connecting Peripherals
2.1 Introduction
You can access most of the connectors from the top of the board while it
is installed in the chassis. If you have a number of cards installed or have
a packed chassis, you may need to partially remove the card to make all
the connections.
2.2 1st & 2nd (CN1, CN2) IDE Connectors
You can attach up to four IDE (Integrated Drive Electronics) drives to the
PCA-6188’s built-in controller. The primary (CN1) and secondary (CN2)
connectors can each accommodate two drives.
Wire number 1 on the cable is red or blue and the other wires are gray.
Connect one end to connector CN1 or CN2 on the single board computer.
Make sure that the red/blue wire corresponds to pin 1 on the connector (in
the upper right hand corner). See Chapter 1 for help finding the connec-
tor.
Unlike floppy drives, IDE hard drives can connect in either position on
the cable. If you install two drives to a single connector, you will need to
set one as the master and the other as the slave. You do this by setting the
jumpers on the drives. If you use just one drive per connector, you should
set each drive as the master. See the documentation that came with your
drive for more information.
Connect the first hard drive to the other end of the cable. Wire 1 on the
cable should also connect to pin 1 on the hard drive connector, which is
labeled on the drive circuit board. Check the documentation that came
with the drive for more information.
Connect the second hard drive to the remaining connector (CN2 or CN1),
in the same way as described above.
CN1
CN2
- Copyright Notice 2
- PCA-6188 User’s Manual vi 6
- 1.0.3 Release Note 7
- Important Safety Information 8
- SAFETY INSTRUCTIONS 8
- PCA-6188 User’s Manual xvi 16
- General Information 17
- 1.1 Introduction 18
- 1.2 Features 19
- 1.3 Specifications 20
- 1.3.4 VGA interface 21
- 1.3.5 Ethernet LAN 21
- 1.3.6 Industrial features 21
- 1.4 Jumpers and Connectors 22
- Table 1.2: Connectors 23
- PCA-6188 User’s Manual 8 24
- 1.6 PCA-6188 Block Diagram 25
- 1.7 Safety Precautions 26
- 1.8 Jumper Settings 27
- 1.9 System Memory 28
- 1.11 Processor Installation 30
- Connecting Peripherals 31
- 2.1 Introduction 32
- 2.4 Parallel Port (CN4) 33
- 2.5 USB Ports (CN6,CN63) 34
- 2.6 VGA Connector CN7 34
- 2.7 CRT-2 connector VCN2 35
- 2.8 LVDS connector VCN4 35
- 2.9 DVI connector VCN5 36
- 21 Chapter 2 37
- User’s Manual 22 38
- 2.15.1 Power LED (CN16) 39
- 2.15.3 Reset (CN18) 39
- 2.15.4 HDD LED (CN19) 40
- 25 Chapter 2 41
- SA0 & SA1 41
- CPU Card 42
- SNMP-1000 42
- Award BIOS Setup 43
- Chapter 3 Award BIOS Setup 44
- 3.2 Entering Setup 45
- 3.3 Standard CMOS Setup 45
- 3.4 Advanced BIOS Features 46
- 31 Chapter 3 47
- 3.4.15 Security Option 48
- 3.4.16 APIC Mode 48
- 3.5.1 DRAM Timing Selectable 49
- 3.5.2 CAS Latency Time 49
- PCA-6188 User’s Manual 34 50
- 3.6 Integrated Peripherals 51
- 3.6.1 IDE HDD Block Mode 52
- 3.6.2 On-Chip IDE Device 52
- 3.6.3 On-Chip Serial ATA 52
- 37 Chapter 3 53
- PCA-6188 User’s Manual 38 54
- 3.7 Power Management Setup 55
- PCA-6188 User’s Manual 40 56
- 41 Chapter 3 57
- 3.8 PnP/PCI Configurations 58
- 3.9 PC Health Status 59
- PCA-6188 User’s Manual 44 60
- 3.11 Password Setting 61
- 3.12 Save & Exit Setup 61
- 3.13 Exit Without Saving 61
- Please Enter Your Password 61
- PCA-6188 User’s Manual 46 62
- Chipset Software 63
- Installation Utility 63
- 4.1 Before you begin 64
- 4.2 Introduction 64
- 4.3 Windows XP Driver Setup 65
- PCA-6188 User’s Manual 50 66
- 51 Chapter 4 67
- PCA-6188 User’s Manual 52 68
- VGA Setup 69
- Chapter 5 VGA Setup 70
- 5.2 Windows XP Driver Setup 71
- PCA-6188 User’s Manual 56 72
- 57 Chapter 5 73
- PCA-6188 User’s Manual 58 74
- LAN Configuration 75
- Chapter 6 LAN Configuration 76
- 6.3 Installation 77
- "Next" to continue 78
- 63 Chapter 6 79
- PCA-6188 User’s Manual 64 80
- USB 2.0 Configuration 81
- 7.1 Introduction 82
- 7.2 Features 82
- 7.3 Installation 82
- Onboard Security Setup 83
- 8.1 Introduction 84
- 8.2 Windows XP Driver Setup 85
- PCA-6188 User’s Manual 70 86
- 71 Chapter 8 87
- PCA-6188 User’s Manual 72 88
- 73 Chapter 8 89
- PCA-6188 User’s Manual 74 90
- SATA RAID Setup 91
- Chapter 9 SATA RAID Setup 92
- 9.3.1 Managing Arrays 93
- 9.3.2 Creating Arrays 94
- 9.3.4 Add/Delete Hotspares 94
- 9.4 Installing the driver 95
- PCA-6188 User’s Manual 80 96
- Programming the 97
- Watchdog Timer 97
- A.1.1 Watchdog timer overview 98
- A.1.4 Example Program 101
- PCA-6188 User’s Manual 86 102
- 87 Appendix A 103
- PCA-6188 User’s Manual 88 104
- 89 Appendix A 105
- PCA-6188 User’s Manual 90 106
- I/O Pin Assignments 107
- Appendix B Pin Assignments 108
- B.5 VGA Connector (CN7) 111
- B.6 VCN2 VGA-2 connector 112
- B.7 VCN4 LVDS connector 112
- B.8 VCN5 DVI connector 113
- B.13 Power LED (CN16) 116
- B.15 Reset Connector (CN18) 117
- Pin Signal 118
- 103 Appendix B 119
- 2PWR-BTN 119
- PCA-6188 User’s Manual 104 120
- 1 Enable OBS alarm 120
- 2 Disable OBS alarm 120
- B.21 SM Bus Connector (CN29) 121
- B.22 System I/O Ports 122
- B.23 DMA Channel Assignments 123
- B.24 Interrupt Assignments 123
- B.25 1st MB Memory Map 124
- B.26 PCI Bus Map 124
Related products and manuals for Processors Advantech PCA-6188
Processors Advantech SOM-5786 User Manual
(32 pages)
(32 pages)
Processors Advantech MIC-3369C User Manual
(86 pages)
(86 pages)
Processors Advantech EVA-X4300 User Manual
(58 pages)
(58 pages)
Processors Advantech PPC-6150A User Manual
(80 pages)
(80 pages)
Processors Advantech PPC-6170A User Manual
(74 pages)
(74 pages)
Processors Advantech SOM-5786 User Manual
(49 pages)
(49 pages)
Processors Advantech AIMB-203 User Manual
(122 pages)
(122 pages)
© 2020, manymanuals.com. All rights reserved. | 0.735 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals