Advantech PCL-740 User Manual download pdf (Page 65)

55 Chapter 4

In the Configure Port dialog box, you can configure the Baud Rate, Data

bits, Parity, Stop Bits and the flow control mode for that specific port (or

for all ports). After you have configured all the settings you want to

change, click OKto make this configuration active.

Run the Test

After you have completed the configuration of the port(s), you can now

start the test on the port you have selected by clicking the Run button

or accessing the Port/Run menu command (or you want to run all ports at

once, just click the All Ports Run button or access All Ports/Run

menu command).

Once the test is started, you can see relevant test information of port per-

formance on the performance listing area.

Figure 4.5: Test Information on the Performance Listing Area

NOTE: When using All Ports Setup button or All Ports/

Setup menu command to configure settings

for all ports, you must take care to stop any ports

that are running test in order to configure them. If

you do not stop the test running on a specific

port, it won’t be configured at all. That is, you get

to configure only the ports that have been

stopped.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 79 80

No comments

Advantech PCL-740 User Manual Page 65