Advantech MIC-3358 User Manual download pdf (Page 37)

29 Chapter 2

of MIC-3358 help you install and remove the card easily and safely. Fol-

low the procedure below to install the

MIC-3358 into a chassis:

To install a card:

1. Hold the card vertically. Be sure that the card is pointing in the correct

direction. The components of the card should be pointing to the right-

hand side.

2. Pull out both handles to unlock it.

Caution: Keep your fingers away from the hinge to prevent your

fingers from getting pinched.

3. Insert the card into the chassis by sliding the upper and lower edges of

the card into the card guides.

4. Push the card into the slot gently by sliding the card along the card

guide until the handles meet the rectangular holes of the cross rails. Note:

If the card is correctly positioned and has been slid all the way into the

chassis, the handle should match the rectangular holes. If not, remove the

card from the card guide and repeat step 3 again. Do not try to install a

card by forcing it into the chassis.

5. Pull the upper handle down and lift the lower handle up to push the

card into place.

6. Secure the card by pushing in the red handle to lock it into place.

To remove a card:

1. Unscrew the screws on the front panel.

2. Lift the upper handle up and press the lower handle down to release the

card from the backplane.

3. Slide the card out.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 83 84

No comments

Advantech MIC-3358 User Manual Page 37