25 Chapter 4 Alarm Module
• One ‘voltage signal’ connector (connect from the backplane /
motherboard, supporting six voltages:
±12 V, ±5 V, +3.3 V, and
+5 Vsb)
• One ‘hard disk LED’connector (connect from the CPU card / moth-
erboard)
Output Signals:
• One ‘LED board’ connector
• One ‘buzzer’ output
4.2.1 Connectors, Jumper and Pin Definition
Table 4.1: CN1, Auxiliary external power connector, standard mini 4-
Pin power connector
Pin 1 +12 V Pin 3 GND
Pin 2 GND Pin 4 +5 V
Table 4.2: CN4, Thermal sensor (LM75) connector
Pin 1 +5 V Pin 3 T_SDAT
Pin 2 T_SCLK Pin 4 GND
Table 4.3: CN13, Voltage detection input connector
Pin 1 +5 Vsb Pin 5 +5 V
Pin 2 GND Pin 6 +3.3 V
Pin 3 GND Pin 7 -12 V
Pin 4 -5V Pin 8 +12 V
Table 4.4: CN16, Power good input connector
Pin 1 Power Good Pin 2 GND
Table 4.5: CN17, Alarm reset connector
Pin 1 ALARM RESET Pin 2 GND
Comments to this Manuals