Advantech AIMB-760 User Manual download pdf (Page 39)

27 Chapter 4 Alarm Module

4.2.2 Switch Settings

The alarm board is designed to connect with up to 7 fans. Users can set

the fan number by adjusting the switch, SW1, on the alarm board.

4.3 Thermal Sensor

The ACP-4010 is configured with a thermal sensor located at the rear

plate of the chassis. (see Figure 4.2)

Figure 4.2: Thermal sensor location

Table 4.11: SW1, Fan number setting

Fan Number SW 1-1 SW 1-2 SW 1-3 SW 1-4

0 OFF OFF OFF OFF

1ONOFFOFFOFF

2 (default) OFF ON OFF OFF

3ONONOFFOFF

4 OFF OFF ON OFF

5 ON OFF ON OFF

6 OFF ON ON OFF

7ONONONOFF

Note: Please connect the fan connectors in the correct sequence: If two

fans are set on SW1, the correct method to connect them into connectors

FAN1 and FAN2. If the two fans are connected to other fan connectors,

out of sequence, such as FAN1 and FAN3 or FAN2 and FAN3 or FAN3

and FAN4, then the alarm will not function correctly.

Thermal sensor

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 47 48

No comments

Advantech AIMB-760 User Manual Page 39